GC EVERSTICK C AND B

Product code : GC 9

Brand : GC

Cod Available : Yes

Cod Charges : ₹0.00

Color

Size

Strength

Qty.

Price

For bulk pricing leave us a message on dentalaaka@gmail.com.

EverStick glass fiber reinforcements have been developed to provide solutions for modern, patient-friendly dentistry.
EverStick fiber reinforcements are made of silanated glass fibers in thermoplastic polymer and light curing resin matrix.
EverStick products address the advantages of minimally invasive dentistry where the patient´s own healthy tooth tissue is saved for as long as clinically possible.
This also means that other treatment options remain available should the patient ever need them in the future.
INDICATIONS-
For minimally invasive fiber reinforced composite bridges.
Surface retained bridges.
Inlay and onlay bridges.
Hybrid bridges and temporary bridges.
Laboratory-made bridges.

Directions to use:

Step 1: Measure the length of fibre needed

Step 2: Cut the fibre inside the silicone

Step 3: Clean the teeth with pumice and water

Step 4: Etch the teeth for 45-60 seconds

Step 5: Bond the etched area and light-cure

Step 6: Apply a flowable composite; do not light-cure

Step 7: Position the fibre on top of the flowable

Step 8: Spread the fibre on the surface of the first tooth

Step 9: Light-cure while protecting the rest of the fibre

Step 10: Bend the centre of the fibre labially to support the pontic, and hold it in position. Do not light-cure.

Step 11: Spread the fibre on the surface of the second tooth, while keeping the labial curvature. Light-cure the complete structure.

Step 12: Add a transverse fibre occlusally; cover with flowable & light-cure

Step 13: Layer the pontic with composite

Step 14: Finish and check the occlusion

Clinical Tips for Anterior bridges
Keep the fibre protected from the light to avoid premature curing.
By removing old restorations, you can obtain space for the fibre frame without additional preparation of the teeth.
In anterior bridges, attach the fibre frame as incisally as possible to allow maximum support for the bridge.
At the occlusal contact, the optimal thickness of the composite layer on top of the fibre frame is 1-2mm. Apply StickRESIN, thin with air, light-cure and cover again with composite.
Attach a transverse fibre with flowable composite on the occlusal side to support the pontic.
The fibres must be entirely covered with composite. Use thixotropic GC flowables for a precise application.
If you notice after placement that the fibre is too long, shorten it with a diamond bur during the finishing phase. Make sure not to cut the fibres
Store the package in the refrigerator.

Everstick C And B 2 x 12Cm

Everstick C And B 1 x 8Cm